7dpo... 9dpo FRER added

I don't see anything on today's ICs
 

Attachments

  • IMG_7457.jpg
    IMG_7457.jpg
    21.5 KB · Views: 43
  • IMG_7456.jpg
    IMG_7456.jpg
    22.5 KB · Views: 19
  • IMG_7458.jpg
    IMG_7458.jpg
    21.4 KB · Views: 15
  • IMG_7454.jpg
    IMG_7454.jpg
    21.1 KB · Views: 11
I'm sure I can see a line on the untweeked one x
 
When I finally got my bfp, the cheapies were the last to show anything. I do think I saw a hint of a line on the FRER! good luck!
 
Sorry my eyes went funny and only saw one test- I see it on the top test for sure!
 
When I zoom into the greyscale photo a little, I see what looks like the faintest and skinniest of lines starting to appear but I don't see it on the others. I do see the small dent near the control line on the top test, though, but I don't see anything else and I think the grey photo may be a fluke
 
So I can see a super faint skinny line on the wider IC with today's fmu but my camera won't show it properly! I got excited initially but then I don't know if I can trust these ICs. Waiting on a FRER
 
So I could easily see the line when the IC was wet but my camera couldn't get a clear photo of it. It's showing up easily on my camera dry though, so will post photos. Did a FRER with saved fmu, I don't see anything! Confused. I have read that FRERs are sensitive to 12.5miu and 6.5miu although I don't know whether the 6.5miu is referring to the curved type. Anyway, these ICs are meant to be 10miu, so I have concluded 1. They are absolute rubbish and have given me a fake line, or 2. Are slightly more sensitive than the FRER. It showed within the timeframe and I can see it isn't a dent (there are a few on these, but what I'm seeing isn't a dent or scratch, I have checked a zillion times!) :shrug:
 

Attachments

  • IMG_7712.jpg
    IMG_7712.jpg
    17.9 KB · Views: 28
  • IMG_7713.jpg
    IMG_7713.jpg
    17.7 KB · Views: 11
  • IMG_7714.jpg
    IMG_7714.jpg
    16 KB · Views: 10
The FRER in the case
 

Attachments

  • IMG_7721.jpg
    IMG_7721.jpg
    31.8 KB · Views: 50
  • IMG_7727.jpg
    IMG_7727.jpg
    30.9 KB · Views: 26
  • IMG_7723.jpg
    IMG_7723.jpg
    31.5 KB · Views: 14
And out of the case...
 

Attachments

  • IMG_7715.jpg
    IMG_7715.jpg
    37.8 KB · Views: 32
  • IMG_7731.jpg
    IMG_7731.jpg
    50.7 KB · Views: 11
  • IMG_7732.jpg
    IMG_7732.jpg
    48.7 KB · Views: 12
I still see it. But since it's been 2 days I think it should be a bit darker than before. They look almost the same on here. I hope they get darker for you!
 
I can see a fairly obvious line on the IC which is an improvement on yesterday's blank ICs, if of course it's actually a real line and isn't a faulty test! But I don't see anything on the FRER and the FRER at 9dpo was questionable I think. If it was a proper line at 9dpo then I ought to have a much clearer line on them by this point, so I think perhaps I have gone insane and also possibly have a faulty IC. Will continue to pee on every stick in sight though
 
I can see a fairly obvious line on the IC which is an improvement on yesterday's blank ICs, if of course it's actually a real line and isn't a faulty test! But I don't see anything on the FRER and the FRER at 9dpo was questionable I think. If it was a proper line at 9dpo then I ought to have a much clearer line on them by this point, so I think perhaps I have gone insane and also possibly have a faulty IC. Will continue to pee on every stick in sight though

LOL. I am completely the same way. And I used (and use currently) some ICs that I see a line on basically every time! It's so frustrating but I will use them until I run out and buy a different kind.
Also you're not out until the witch shows, x!
 
I can see a fairly obvious line on the IC which is an improvement on yesterday's blank ICs, if of course it's actually a real line and isn't a faulty test! But I don't see anything on the FRER and the FRER at 9dpo was questionable I think. If it was a proper line at 9dpo then I ought to have a much clearer line on them by this point, so I think perhaps I have gone insane and also possibly have a faulty IC. Will continue to pee on every stick in sight though

LOL. I am completely the same way. And I used (and use currently) some ICs that I see a line on basically every time! It's so frustrating but I will use them until I run out and buy a different kind.
Also you're not out until the witch shows, x!

Thanks :)
I had an IC a couple of cycles back show a faint line but it was wider and grey ish, and then last cycle the same brand I'm currently using (because I ordered about a million of them at once) gave me a bizarre pink blurry blobby smudge which wasn't anything as af showed.
I have had definite faint lines on FRER before but af showed so I don't know whether that was a cp or a rubbish test.
These FRERs apparently are 12.5miu (UK) so in theory are less sensitive than the ICs but I can't trust the ICs lol
I was more hopeful earlier today because my temp stayed put whereas each cycle by 11dpo it dips and also I usually have sore boobs and nausea from early on in my lp but this has started happening only yesterday and I had a big temp dip followed by a sharp rise in temp plus cervix feels high and closed x
 
Didn't have anything on the FRER with today's fmu or on the CB+ with smu but I have a clear faint line on an IC this evening and a dark opk. Confusing. Temp was up today too, will post a photo of it in comparison to previous couple of cycles but tbh without anything on a better test I think I'm clutching at straws
 

Attachments

  • IMG_8102.jpg
    IMG_8102.jpg
    34.3 KB · Views: 36
  • IMG_8103.jpg
    IMG_8103.jpg
    33.7 KB · Views: 14
  • IMG_8104.jpg
    IMG_8104.jpg
    32.6 KB · Views: 14
  • IMG_7810.jpg
    IMG_7810.jpg
    37.6 KB · Views: 7
So weird. I can see it plain as day on the ICs. I wish I could spend 100s of dollars on only the expensive tests. It would save a lot of confusion.
I would keep going if I were you, see if there is progression.
 
I see it clearly on the IC and that OPK is rather dark (mine went dark as I started to get lines on HPT). Good luck!
 

Users who are viewing this thread

Members online

No members online now.

Latest posts

Forum statistics

Threads
1,650,212
Messages
27,141,963
Members
255,683
Latest member
chocolate 4
Back
Top
monitoring_string = "c48fb0faa520c8dfff8c4deab485d3d2"
<-- Admiral -->